Dimpled Membrane
Carpet Subfloor
Tile Subfloor
Laminate & Engineered Wood Subfloor
Warm N Quiet Subfloor
Shower N Floor
SuperDrain
Tunnel Drainage

Brochure
Specifications
Installation Instructions
Warranty


CARPET SUBFLOOR MEMBRANE
Double Dimple Carpet Solution

SUPERSEAL Carpet Subfloor can now be purchased at your local Menards store 		Buy SUPERSEAL Carpet Subfloor Membrane Online Like SUPERSEAL on facebook
SUPERSEAL Carpet Subfloor Membrane is a moisture barrier and thermal break membrane with a unique double dimple design. Tack strips can be nailed right through the membrane in carpet installations.
Carpet Subfloor Membrane - Profile Carpet Subfloor height

PRODUCT BENEFITS

Tack Strips Can be Nailed Through Membrane
Holds the membrane in place while protecting the entire floor assembly from moisture.

Unique Double Dimple Design
Allows both the substrate and the flooring to breathe.

Extremely High Compressive Strength
Furniture legs will not damage or crush it.

Ultra Thin Profile 0.11" (2.8mm)
Fits under most existing baseboards and door casings and provides minimal transitions between flooring surfaces

Easy Installation - No Special Fasteners
Carpet Subfloor is 10x faster and 90% lighter than plywood subfloors.

Economically Priced, High Performance Subfloor
Eliminates additional costs as compared to plywood systems.

Permanent Moisture Barrier
Stops substrate moisture from absorbing into underlay, carpet and wood.

CARPET SUBFLOOR VS ALL-IN-ONE


SUPERSEAL Carpet Subfloor is designed to have a tack strip nailed through it. In adddition, the unique Double Dimple design gives the Carpet Subfloor unmatched strength compared to anyone on the market today. This means the most table and chair legs will not affect the performance of the membrane.

All-In-One Subfloor can be used under carpet, BUT you can not nail a tack strip through it. You must install the All-In-One 1/4 inch away from the inside edge of the tack strip. In addition, it is not as strong as the Carpet Subfloor when it comes to table and chair legs.

INSTALLATION TIPS
Detailed Installation Instructions

Climatize the Roll

Because plastic and wood both expand and contract in heat and cold, SUPERSEAL Carpet Subfloor needs to be properly climatized for approximately 12-24 hours at a temperature between 60-80ºF (15-26ºC) prior to installation.

Cut and remove the tape that is keeping the roll together and loosen it up a little to allow it to expand properly. You can also pre cut the roll to size before you climitize it, however you may have to trim the edges again before you install the tack strip.

When unrolling the membrane, you must flip it over before taping the seams or installing the tack strip. This will help prevent the membrane from rolling back up.

Seams

When installing SUPERSEAL Carpet Subfloor and you have a seam, butt the 2 pieces together and tape the seam using SUPERSEAL Subfloor Tape.